Humminbird LCR 400 ID User Manual download pdf (Page 7)

Step 4

TRANSDUCER ASSEMBLY- Insert the transducer assembly into the metal bracket

from the bottom. Push up until the holes in the plastic pivot align with the uppermost

holes in the bracket. Slide the O-ring on to the headed pin and insert it through the two

parts. Assemble by screwing the ¼”x3/8” allen head screw into the end of the pin and

tighten. (See Figure G)

Step 5

ANGLE ALLIGHMENT- Set the transducer angle so that it is parallel with the bottom of

the boat hull. Once proper alignment is achieved, tighten the two allen head screws

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Humminbird LCR 400 ID User Manual Page 7