Humminbird 531906-1EN_A User Manual download pdf (Page 32)

Change the GPS Source

To change the GPS source after the network has been configured, open the

Network Source Setup dialog box to change the GPS sources at any time.

Network settings are saved even after the unit is powered off.

If the control head cannot detect the set GPS receiver, the control head will

display an error message so that you can reset the GPS source as follows:

• If the shared GPS receiver is not detected, the control head will

switch automatically to the local GPS receiver. Follow the on-screen

instructions to permanently save the local GPS receiver as the selected

source.

• If the local GPS receiver is not detected, the GPS data will flash. If

there isn't data displayed in the digital readout box, the source has

been lost. See Select a GPS Source to select another GPS Receiver in

the network.

If the control head cannot detect the shared GPS Receiver set in the network, follow the

on-screen instructions to change the GPS source. Press the LEFT Cursor key to select No,

or press the RIGHT Cursor key to select Yes.

Finding the GPS Source

700 Series™

GPS Sources

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39

No comments

Humminbird 531906-1EN_A User Manual Page 32